Unpacking method
Unpacking and Charging Sensors
- Take out all the boxes & foam.
- Find sensors in the sensor box
and the magnetic charging cable
in the toolbox with the logo and
charge the sensors to prepare for
pairing.
*
Charging Light Status:
Shoe Sensor - Flashing;
Inner Sensor - Dimming.
Disassemble the Carton
- Find gloves in the toolbox
and wear throughout the
entire procedure.
- Cut the corners of the
cartons and flip the flat as
shown.
- DO NOT cut any of the black
ties. Especially under the
walking base. Horizontally
take out the support rod.
Taking out the Components
- Cut only all the white ties that
bind the bubble wrap around
the base.
- Slowly and horizontally take
out all the components under
the base.
Connecting the Base
- Grab and Lift one side of
the base (39kg) and rotate it
out from the package. Place
it on a flat surface with the
cable facing the PC.
- Open the toolbox and
place it on the base for easy
access.
- Take out the data cable
and connect it to the PC
USB port.
Software Setup
- Download and install KAT
Gateway(www.kat-vr.com/pa
ges/support).
- Pair the sensors following
software prompts and update
to the latest firmware version.
Check the Gateway to
ensure the sensors are
detected properly as shown.
Mounting the Inner Sensor
- Don't begin this step until
you have completed the
sensor preparation.
- Find the screwdriver and the
S thin screws.
- Mount the inner sensor on
the top shell with the sensor
data port upward (List: No. 7).
12
Summary of Contents for KAT Walk Coord 2 Core
Page 28: ...www kat vr com...
