ADSL ROUTER
USER MANUAL
4
1.3
System
Requirements
Before using this ADSL router, verify that you meet the following requirements:
Subscription for ADSL service. Your ADSL service provider should provide you
with at least one valid IP address (static assignment or dynamic assignment via
dial-up connection).
One or more computers, each contains an Ethernet 10/100M Base-T network
interface card (NIC).
A hub or switch, if you are connecting the device to more than four computers.
For system configuration using the supplied web-based program: A web browser
such as Internet Explorer v5.0 or later, or Netscape v4.7 or later.
1.4
Factory
Defaults
The device is configured with the following factory defaults:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Encapsulation: RFC 2516 LLC
VPI/VCI: According to local information
1.5
Warnings and Cautions
Never install telephone wiring during storm. Avoid using a telephone during an
electrical storm. There might be a risk of electric shock from lightening.
Do not install telephone jacks in wet locations and never use the product near
water.
To prevent dangerous overloading of the power circuit, be careful about the
designed maximum power load ratings. Not to follow the rating guideline could
result in a dangerous situation.
Please note that telephone line on ADSL router must adopt the primary line that
directly outputs from junction box. Do not connect ADSL router to extension
phone. In addition, if your house developer divides a telephone line to multi
sockets inside the wall of house, please only use the telephone that has
connected with the splitter of ADSL router when you access the Internet. Under
the above condition, if you also install telephone with anti-cheat-dial device,
