STEP SEVEN
Position the Bottom Screen (Part B9) over the float so
the motor housing (can) passes through the large hole
in the center of the screen. Remove the center three
Lock Nuts from the 9” Bolts and place the Bottom
Screen Clips (Part B13) over the bolts as shown. The
power cord can be slid under the bottom screen where
two float sections
come together before
the Lock Nuts are
replaced. Replace
the three inside Lock
Nuts and tighten all
3/8” Lock Nuts us-
ing the
9/16” (14mm)
wrench and socket.
Note: Extra hardware may be included
STEP EIGHT
Return the unit to its upright position and select a
nozzle (See page 10 for Nozzle and Pattern Options).
Select the proper Shaft Bolt (Part D2) and insert the
Shaft Bolt into the Nozzle Head so it fits snugly into
the molded socket. Install the Nozzle by threading it
into the inner cone of the pump. Make sure to tighten
the Nozzle all the way down.
To install the Redwood nozzle, make sure the Y In-
sert (Part D4) is installed and seated properly into the
nozzle. Push the nozzle down over the cone assem-
bly (it may require light taps with a rubber mallet to
seat properly). Next, use the 3 Self Tapping Screws
(Part D1) provided in the 3 holes on the nozzle and
tighten the screws into the cone assembly. Once you
feel resistance, two more turns will be sufficient. To
install the Spruce nozzle, follow the same steps, but
do not install the Y Insert.
STEP NINE
The power cord should now be attached to the stub
cord by lining up the male and female halves of the
disconnect and hand tightening the blue collar. On
these cords, the Additional Strain Relief should be
attached to one of the lower float brackets as pic-
tured. If there is not Strain Relief, use the Nylon Ca-
ble Tie provided to secure the cord to a rope to pre-
vent damage by the propeller. Double check the
Quick Disconnect to make sure the threaded collar
has not come loose in shipping before placing in the
water. If installing a new Quick Disconnect, please
refer to Quick Disconnect instructions on page 4-5.
Also, at this time, lights can be installed if purchased.
13
Pictures correspond
with Step Six on
previous page
