Horizontal Float
Assembly & Installation Instructions
A. Circulator (Unit with cord) (1)
B. Float in separate box (1) (Diagram to Right)
1. Float (1)
2. Base Strap (1)
3. Adjustment Bracket (1)
4. Angle Bracket (3)
5. Draw Band (1)
6. U-Bracket (2)
7. Spacer Bracket (2)
8. 1/4” x 1/2” Stainless Steel Bolt (8)
9. 1/4” x 1” Stainless Steel Bolt (3)
10. 1/4” x 1-1/4” Stainless Steel Bolt (2)
11. 1/4” Stainless Steel Lock Nut (8)
12. 1/4” Stainless Steel Hex Nut (2)
13. 1/4” Stainless Steel Lock Washer (5)
14. 50’ Black Nylon Ropes (2)
15. Nylon Tie (1)
PARTS INCLUDED
TOOLS & SUPPLIES NEEDED
•
7/16” Wrench (1)
•
7/16” Socket & Ratchet (1)
•
Felt-Tip Marker (1)
STEP ONE
Remove all contents from package and place on a
clean, flat surface. Inspect the shipment for any dam-
ages. If damages are found, immediately notify your
carrier and your Kasco Marine, Inc. representative.
Make sure you have all the parts needed. If any
shortages are found, contact your Kasco representa-
tive immediately.
STEP TWO
Position the Float upside down (lengthwise channels
facing up) and place the Base Strap so the three holes
in the Base Strap align with the three threaded holes
that comprise the lengthwise midline of the Float.
STEP THREE
Position the Adjustment Bracket over the two holes at
the back end of the Float and Base Strap. Loosely
secure the Adjustment Bracket to the Float using two
1/4” x 1/2” Stainless Steel Bolts and two Stainless
Steel Lock Washers. (See photo above for orienta-
tion.)
STEP FOUR
Place one of the three Angle Brackets perpendicular
to the Base Strap at the front end of the Base Strap.
One of the two center holes of the Angle Bracket
should be positioned over the hole in the Base Strap
and the threaded hole in the Float. Secure the Angle
Bracket to the Float using three 1/4” x 1/2” Stainless
Steel Bolts and three Stainless Steel Lock Washers.
(See photos on the next page for specific instructions
based on the size circulator purchased.) Tighten all
hardware at this time with the 7/16” socket and
wrench.
•
Anchors or Stakes for Installation (2)
•
12” pieces of 1” galvanized pipe for weighting
ropes (optional) (2)
17
