8
C-25 Timer Control
Portable Timer with Ground Fault Interrupter
IMPORTANT
This portable timer is designed for CON-
TROLLING the connected equipment only.
Unplug timer before servicing the unit or the
equipment it controls. For maximum protec-
tion against electrical shock hazard, perform
test procedure on G.F.C.I. at least once a
month. Mount at least 5 ft. from open water.
G.F.C.I. TEST PROCEDURE
The G.F.C.I. should be checked every month
to make sure that it is operating properly. Just
follow the simple instructions below. It is rec-
ommended to maintain a maintenance diary of
your monthly safety check.
1. Push TEST button, RESET button should
pop out from inner surface. This should result
in power being OFF at the outlet protected by
the G.F.C.I. Verify by plugging a test lamp
into the outlet. Be sure the timer is in the ON
position.
2. If the G.F.C.I. tests okay, restore power by
pushing the RESET button back in. THE RE-
SET BUTTON MUST BE PUSHED FIRMLY
AND FULLY INTO PLACE UNTIL IT
LOCKS AND RE-MAINS DEPRESSED AF-
TER PRESSURE HAS BEEN REMOVED.
DANGER: IF RESET BUTTON DOES
NOT POP OUT, IF TEST LAMP REMAINS
LIT WHEN RESET BUTTON DOES POP
OUT, OR IF THE G.F.C.I. FAILS TO RESET
PROPERLY, DO NOT USE TIMER! CON-
TACT A QUALIFIED SERVICE TECHNI-
CIAN!
Failure to use the C-25 with Kasco Fountains
will void the warranty and cause the Fountain
Eagle’s Nest:
Produces a wide “V” pattern of water 3.5 feet
high by 10 feet in diameter.
This nozzle does not use the upper pump
housing. It has the number 4 molded near the
screw collar of the nozzle.
Hawk’s Nest:
Produces a narrow “V” pattern of water 3 feet
high by 7 feet in diameter.
This nozzle does not use the upper pump
housing. It has the number 5 molded near the
screw collar of the nozzle.
Upper Pump Housing:
Must be installed
and used with the
Osprey, Condor, and
Falcon nozzles. Must
be removed to use
the Eagle’s Nest and
Hawk’s Nest nozzles.
Hint: Keep the osprey
nozzle attached to the
upper pump housing to help you pull the up-
per pump housing out of the fountain tube
for cleaning or nozzle changes
.