Kasco Aeration 3400JF, Owner'S Manual, Page: 6 / 24

6
4400JF, 4400HJF Parts Included
4400JF Aerating Fountain (Unit with cord or unit 1.
with Disconnect) (1)
Float (with two 50’ mooring ropes attached) (1)
2.
1/4-20 x 3 1/2” Phillips Pan Head Screw (4) 3.
1/4” split washers (4) 4.
1/4” (3/4” outer diameter) Flat Washer (4) 5.
3/8”-16 x 1-3/4” Hex Head Bolt (2) 6.
3/8” Flat Washer (4) 7.
Float Retaining Clips (4) 8.
Bottom Screen cushions (3) 9.
Bottom Screen (1) 10.
Bottom Screen Clips (2) 11.
3/8”-16 Nylon Lock Nut (2) 12.
1
2
3
4
5
6
7
8
9
10
11
12
if installed from the bottom or top side of the opening.
It will not fi t if installed from side of opening. Use the
Nylon Cable Tie included to secure the power cord to
a molded hole in the fl oat to prevent cord damage if
there is no strain relief on the cord. If a Strain Relief
is present on the cord, you may disregard the Nylon
Tie. On cords with a Quick Disconnect, the discon-
nect should be tightened properly to avoid leaking.
If installing a new Quick Disconnect, refer to Quick
Disconnect Instructions.
STEP NINE
Select a nozzle (See JF Nozzle Options). Insert the
Shaft Bolt into the Nozzle Head so it fi ts snugly into
the molded socket. Install the Nozzle by threading it
into the inner cone of the pump. Make sure to tighten
the Nozzle all the way down.
STEP TEN
Thread one rope through one weighted tube rope
Weight and position it approximately 6’ from the
fl oat. Next, thread the end of the rope back through
the opening facing the fl oat (as shown). Repeat with
the second rope and weight. If ready to install in the
pond, go to Installation instructions. Light Kits can
also be installed at this time, go to Light kit instruc-
tions.