Kasco Aeration 3400JF, Owner'S Manual, Page: 5 / 24

5
STEP SIX
See “Mesh Screen Attachment” section before con-
necting the bottom screen to the fl oat. Turn secured
assembly upside down so the top of the fl oat (logo
side) is face down on the fl at surface. Place Bottom
Screen (Part 10) onto the bottom side of the fl oat.
Make sure the wide opening of the screen is against
the fl oat and the 3 handles on the screen do not in-
terfere with the rope placements. Fit the 3 Bottom
Screen cushions (Part 9) underneath the screen and on
top of the 3 spacing bumps on the bottom of the fl oat.
Bottom Screen cushion
STEP SEVEN
Using a stainless steel Bottom Screen Clip (Part 11),
3/8”-16 x 1-3/8” Bolt (Part 6), two 3/8” Flat Washer
(Part 7), and 3/8”-16 Nylon Lock Nut (Part 12) to
secure the screen to the fl oat. Align a clip so the two
prongs straddle a wire on the screen. Insert bolt with
washer so the top of the bolt is facing the top of fl oat
(now in down position). Place the second washer and
the locking nut with nylon insert on the end of the bolt
and tighten using the 9/16” (14mm) Socket and Ratch-
et on the nut end and the 9/16” (14mm) Wrench on the
bolt end. Tighten until snug and repeat with remaining
clip.
STEP EIGHT
Turn the assembly upright again. At this time, if the
cord contains a metal strain relief, you can use the
chain connector and attach it in one of the opening at
the rope placement. The chain connector will easily fi t
STEP TWO
Set motor housing upright (stainless steel can down)
on a fl at surface.
STEP THREE
Peel off the adhesive on one of the Cushions for the
fountain housing legs (Part 8). Stick to the top of the
fountain housing leg and repeat for the other three
cushions. Rest the fl oat on the 4 legs of the housing
making sure logo on fl oat is up.
cushion
logo
STEP FOUR
Ensure correct alignment by twisting the fl oat gently
around the motor housing until the power cord guide
lines up with the cord. See diagram below of bottom
side of fl oat. The 4 bolt holes in the fl oat should line
up with bolt receptacles on unit.
Bolt holes
power cord
guide
STEP FIVE
Use one of the 1/4”-20 x 3-1/4” Phillips Pan Head
Screws (Part 3), one 1/4” split washer (Part 4), and a
1/4” Flat Washer (Part 5) to secure the fl oat. Make
sure the split washer goes between the bolt head and
the fl at washer. Insert screw with washers through
bolt hole in fl oat
Tighten until snug with a Phillips Head screw driver
and repeat for 3 remaining screws.