Kasco Aeration 3400HJF, Owner'S Manual, Page: 7 / 24

7
R est the fl oat on the cage top ring.
STEP THREE
Ensure correct alignment by twisting the fl oat gently
around the motor housing until the power cord guide
lines up with the cord. See diagram of bottom side of
fl oat.
Bolt holes
power cord
guide
STEP FOUR
Use one of the 1/4”-20 x 3-1/2” Phillips Pan Head
Screws (Part 3), one 1/4” split washer (Part 4), and a
1/4” Flat Washer (Part 5) to secure the fl oat. Make
sure the split washer goes between the bolt head and
the fl at washer. Insert screw with washer through bolt
hole in fl oat
U se one fl oat retaining clip (Part 8) under the top ring
of the cage. There is a U-shaped indent in the clip that
will fi t snug against the top ring of the cage. The 1/4”-
20 x 3-1/2” will then thread into the retaining clip.
fl oat retain fl oat retain
ing clip ing clip
Tighten until snug with a Phillips Head screw driver
and repeat for 3 remaining screws.
Set of 5 Interchangeable Nozzles (5)
1. 3/8” x 2.25” bolt (1)
2. 3/8” x 4” bolt (1)
3. Linden Nozzle (1)
4. Sequoia Nozzle (1)
5. Juniper Nozzle (1)
6. Willow Nozzle (1)
7. Cypress Nozzle (1)
8. Collar for Cypress Nozzle (1)
Also Included:
Mesh screen (1) with cable ties (10) •
Cord in separate box (1) (depending on size of •
cord)
Control Box (C-25 for 120V units in Float box
•
or C-85 for 240V units in separate box) (1) (Not
Pictured)
4400JF, 4400HJF Assembly
STEP ONE
Make sure you have all the parts needed. If any short-
ages are found, contact your Kasco representative
immediately.
STEP TWO
Set motor housing upright (stainless steel can down)
on a fl at surface. With motor housing upright, slide
Float (Part 2) over pump housing making sure the
surface with the Kasco logo is up.
logo