8
ELECTRIC BLENDER
Before assembling the jar, be sure the power cord is unplugged from the
power outlet and the Switch button is on the 0 position.
The jar is suitable for making mixture which the juice and pulp are mixed.
For attaching Jar, Place the Jar into the motor unit
directly in place, (see fig.1).
Note:
make sure the Jar is assembled into the motor
unit properly, there is interlock switch on the position, if
the Jar is not assembled properly, the blender will not
operate. .
Blending fruit and vegetable:
1. Before attaching the power cord into the outlet, make
sure the Switch button is in the 0 position.
2. Peeled or cored the fruit or vegetables and then cut
it into small dices, put the food piece into the Jar.
Usually certain amount of purified water has to be
added to facilitate the smooth running of appliance.
The proportion of the food and water is 2:3.The
amount of mixture should not exceed the max level
as indicated on the Jar.
Note:
never use boiling liquids or run the appliance empty. The Jar can be used
for breaking up ice.
3. Replace the Jar cover on the Jar. Turn the Jar cover into the Jar.
4. Turn the Switch button to the desired setting, there are two settings: P, 0,
1,2. Turn switch to P position and hold it to pulse actuate motor for delicate
chopping. Release it to return the 0 position.
5. The consecutive operation time shall less than 3 minutes. Minimum 1 minutes
rest period is required between two consecutive cycles.
6. Turn the Switch button to 0 Position once the mixture has been blended to your
desired consistency.
7. Remove the Jar from the Motor Unit (remove it by directly upward), carefully
take down the Jar cover, then pour and serve.
Cleaning and Maintenance
The Auto Clean feature can clean the blender and blade assembly easily, rapidly
in complete safety.
-Pour a little warm soapy water into the Jar and turn the Switch button to P
position for a few seconds.
-Remove the Jar from the motor unit by directly taking it upward and rinse the Jar,
Jar cover under running water.
-Wiping the outer surface of Motor Unit with a damp cloth, do not use abrasive
cleansers. Never immerse in water for cleaning
-Dry all parts and then replace them
fig.1
