4
5.
6.
7.
8.
Fan Speed button
Press the Fan Speed button to set the fan speed: high, medium, low. The fan speed can be adjusted
under Auto mode and Cont mode only.
Filter clean
When the filter clean indicator is on, please clean the filter. After the filter is cleaned and installed, press
the Fan Speed button and the Humidity button simultaneously. The filter clean indicator will be off.
Child lock
Press the Mode button and the Timer button simultaneously for 1 second to activate the child lock
protection. “LC” will be displayed. Press the Mode button and the Timer button simultaneously
for 1 second again to release the function.
Memory Function
The appliance will be operated by the mode set before shutdown, but the set humidity level will be
50% and timer function will be off.
If unplugging the appliance directly or power cut, the timer setting will continue to run when
reconnect the power supply and press the ON/OFF button again to turn on the appliance.
PRECAUTIONS
1.
2.
3.
4.
5.
6.
The humidity setting should not be set higher than the ambient humidity to operation.
When the water tank is full or the water tank has not been put on the correct positions for about 3
minutes, the buzzer will be buzzing and the water tank full indicator will be flashing. Please
drain the water, and/or install the empty water tank back to its position. The appliance will return
to standby mode and you can restart the operation by pressing the ON/OFF button.
The operational temperature range of this appliance is 5ºC-35ºC.
If the plug and power supply are in normal condition, and the dehumidifier does not start, please
unplug to wait for 10 minutes and restart the appliance (as it takes around 10 minutes to reposition).
If the appliance still does not start after 10 minutes, please contact the service center.
When the dehumidifier is in operation, the running compressor will get hot and the room
temperature will be increased. This is normal.
The dehumidifying function will stop immediately after shutdown, but there is a small amount of
water will be discharged from the drain hole. When the appliance is not in use for a prolonged
period, please place it for one day before package and storage.
DRAINAGE INSTRUCTION
Note:
1.
2.
Do not remove the water tank when the appliance is in operation or has just stopped.
Do not use the water tube if using the water tank to collect water. When the hose is connected,
water will be drained out through it instead of into the water tank.
While the water tank is full, the buzzer will be buzzing for 10 seconds and the water tank full
indicator will be on. The compressor and the fan will stop operating. Please empty the water tank.
*Please turn off and unplug the appliance before removing the water tank.
1.
Note:
Hold the handles on both sides of the water tank and pull it out. (Fig. 1)
Pull out the water tank carefully to avoid the water spilling out from the water tank.
