Karda KD4000 Series, User Manual

Page: 12 / 36

Chapter 3 Operation Panel
11
II. Digital Keypad Parts and Functions
KEY Functions
For normal operating or programming mode (the key is
always valid)
. Must select programming mode to modify parameters
If the drive is shut down due to a fault occurs, after
troubleshooting, press this button will clear the error
message.
This is data setting key. In normal operating mode, press
this button to display the drive status information, such as
frequency command, output frequency and input current;
in programming mode, press this key to display the
parameter content. Then Press this button again will save
the changed parameters to the internal memory
Select forward or reverse operation. Press this button , the
motor will decelerate to 0HZ and change direction, but
motor will not restart automatically after the shutdown. An
external terminal can control motor forwarding or
reversing, when modify Pr.001 to "d0001" or "d0002"
Press this button ,the motor will run at jog frequency as set
by the parameter specified under Pr.23
start running key (if set to an external terminal control,
press this key is invalid)
Stop key.
Press the “Up” and “Down” button to select or modify
parameters ..
Note: Pressing the “Up” or “Down” button momentarily
changes the parameter settings in increments. Press and
hold these keys to rapidly run through the possible
settings.