Kärcher RCF 3, Manual

Page: 24 / 280

24 English
 Observe the manufacturer's dosing quantity recom-
mendations when dosing with detergent or care
agents.
 To prevent foaming, fill the fresh water tank with wa-
ter first and the add the detergent or care agent.
 To prevent the tank from overflowing, be sure to
leave enough space for the detergent or care agent
when filling with water.
Replacing the cleaning roller
A worn cleaning roller can worsen the cleaning result.
1. Check the cleaning roller regularly for wear and re-
place if necessary.


Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Customer Service department
If the malfunction cannot be corrected, the device must
be checked by the Customer Service department.
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
EU Declaration of Conformity
Alfred Kärcher SE & Co. KG hereby declares that the
ra-dio device type Robo Cleaner complies with the UK
reg-ulation S.I. 2017/1206 (as amended). The full text
of the Declaration of Conformity can be found at
www.kaerch-er.com/RCF3 .
Technical data
Subject to technical modifications.
Fault Cause Rectification
The LED display indica-
tor "Robot status" flash-
es red The battery is discharged. 1. Charge the battery.
The cleaning robot is to be switched off
and is standing on the charging station. 1. Switch off the cleaning robot when it is not
on the charging station
The fresh water tank is not sitting proper-
ly in the device. 1. Remove the fresh water tank and then fit it
back in place. Insert the fresh water tank so
that it is firmly fitted in the device.
The cleaning roller is not fitted properly in
the device. 1. Fit the cleaning roller correctly in the de-
vice.
The cleaning roller is caught or blocked. 1. Remove the cleaning roller and insert it
correctly into the device.
Device Type Frequency
band, MHz Power, max.
EIRP, mW
RCF 3 WLAN 2400-2483.5 100
Alfred Kärcher SE & Co. KG hereby declares that the ra-
dio device type Robo Cleaner complies with the 2014/
53/EU directive. The full text of the EU Declaration of
Conformity can be found at www.kaercher.com/RCF3 .
Device Type Frequency
band, MHz Power, max.
EIRP, mW
RCF 3 WLAN 2400-2483.5 100
RCF 3
Electrical connection
Nominal power W 36
Nominal voltage of battery V 14,4
Battery pack type Li-ION
Nominal voltage of charger V 220-240
Rated current charger A 0,8
Battery capacity mAh 4800
Rechargeable battery nominal ca-
pacity mAh 5200
Operating time in Sensitive mode
when battery fully charged min 125
Wireless connections WLAN
IEEE
802.11b/
g/n 2.4
GHz
Frequency MHz 2400-
2483.5
Max. signal strength, WLAN dBm <20
Water tank filling quantities
Fresh water tank capacity ml 430
Waste water tank capacity ml 115
Dimensions and weights of cleaning robot
Weight kg 4,5
Length x width x height mm 340 x
340x
120
Dimensions and weights of charging station
Weight kg 0,4
Length x width x height mm 142 x
153 x
124
Declaration of Conformity