Kärcher KM 105/180 R Bp Classic, Manual

Page: 23 / 366

-
9
Installation position of roller brush in direc-
tion of travel (top view)
Note: When installing the new roller brush,
ensure correct positioning of the bristle as-
sembly.
 Install new roller brush. The nuts of the
roller brush must be inserted on the
notches of the opposite crank.
Note: Once the new roller brush has been
installed, the sweeping track must readjust-
ed.
Note : The sweeping track is factory-set to
80 mm; it is steplessly adjustable if the
brush roller wears down.
 Switch off suction blower.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Roller brush and side brush control le-
ver (1) backwards: Switches the roller
brush on.
Roller brush control lever (3) back-
wards: Lowers the roller brush.
 Allow the roller brush to run for approx.
10 seconds.
 Roller brush and side brush control le-
ver (1) to middle position.
Roller brush control lever (3) forwards:
Raises the roller brush.
 Raise waste container.
 Drive machine backwards.
 Check sweeping mirror.
The sweeping track should have an even
rectangular shape which is 80-85 mm wide.

Undo and adjust the stop screw for
wear adjustment (12).
Stop screw at the top: narrow sweeping
area.
Stop screw at the bottom: broad sweep-
ing area.

Tighten the stop screw again.
 Check the sweeping area of the roller
brush again as described.
 The side-brushes lift up.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Lower the side brushes using the con-
trol lever and allow them to run for ap-
prox. 10 seconds.
 The side-brushes lift up.
 Drive machine backwards.
 Check sweeping mirror.
The width of the sweeping track should lie
between 40-50 mm.
 Set the sweeping track using the two
adjusting screws.
 Check sweeping mirror.

DANGER
Risk of injury! Always apply the safety bar
when the waste container is raised.
 Lift the emptied waste container to the
end position.
Secure the waste container. See chap-
ter "Securing the raised waste contain-
er".
 Open the side cover as described in
Chapter "Replace brush roller".
 Release the 6 wing nuts on the side
holding plate.
 Loosen 3 nuts (SW 13) on the front
holding plate.
 Press the side seal down (elongated
hole) until it is about 1 to 3 mm to the
floor.
 Screw in the holding plates.
 Repeat the procedure on the other side
of the appliance.
몇 WARNING
Risk of injury!
 Wear a dust mask when working
around the dust filter. Observe safety
regulations on the handling of fine parti-
cles.
 Clean the fine dust filter with the filter
cleaning button.
 Empty waste container.
1 Cover
2 Filter cover (vibrator system)
3 Lock, filter cover (2x)
 Fold cover forwards.
1 Cover
2 Fine dust filter
3 Cross struts
 Open the lock.
 Open filter cap.

Check the fine dust filter, clean or re-
place if necessary.
Note
Exchanging the fine dust filter may only
be done by Kärcher Customer Service.
 Insert and lock the filter cover.
Check and adjust roller brush sweeping
track
Check and adjust sweeping track of the
side-brush
Adjust the side seals
Checking/changing the fine dust filter
25 EN