English
9
KÄRCHER recommends using the suction
hose accessory (sold separately) Order no.
9.505-779.0.
STEP 1:
Connect the suction hose to the water in-
let on the pressure cleaner and drop the
other end into a bucket.
Tip
: If you are not using this accessory, coil a
hose into the bucket and ensure that you only
use a standard hose clamp to connect to the
pressure washer.
CLICK FITTINGS MUST NOT BE USED!
STEP 2:
Fill up your bucket with water.
STEP 3:
Connect the KÄRCHER power cord to an
electricity source and turn on at power-
point. Make sure the high pressure nozzle
is not connected and turn the unit on at the
ON/OFF switch. Press the trigger on the
gun - the unit is ready for use once there
is a constant water system.
STEP 4:
Connect the high pressure nozzle and
press the hand trigger to begin cleaning.
Caution
Dry runs lasting longer than two minutes lead
to damages to the high pressure pump. If the
appliance does not build up pressure within
two minutes, switch it off and proceed as in-
structed in the Chapter "Troubleshooting".
Illustration
Push the spray lance into the trigger gun
and fasten it by turning it through 90°.
Illustration
Unwind the high pressure hose from the
hose drum. Hold on to the transport han-
dle during this procedure.
Note
: If the hand crank is in its secured
position, fold it up first.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance “I/ON”.
How to draw water from a bucket when us-
ing a KÄRCHER Pressure Cleaner
Start up