8
English
Mount loose parts delivered with appliance
prior to start-up.
Illustration
Push the wheels into the intake and se-
cure with the enclosed plugs, watch for
positioning of plug.
Illustration
Place the bottom holder into the recesses
and push forward until it audibly locks in.
Insert the top holder and push down all
the way.
Illustration
Press in the storage hook and lock it into
the top position.
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Slide the transport handle into the guide
and secure it with 2 screws.
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Insert both detergent hoses onto the hose
fittings.
Install the dosage regulator and connect
using 2 screws.
Note
: During installation you must make
sure that the tongues of the dosage regu-
lator match up with the intended recesses
in the casing.
Illustration
Slide the free end of the coiled high pres-
sure hose through the recesses on the
dosage regulator.
Insert the hose drum into the intakes on
the transport handle.
Insert the axle of the hand crank into the
guides.
Install the fixating plate and secure it us-
ing 2 screws.
Press the connecting fitting from the short
high pressure hose into the brass intake,
secure with clamps.
Note:
Make sure the connection nipple is
aligned correctly.
Illustration
Push the high pressure hose into the trig-
ger gun until it locks audibly.
Note:
Make sure the connection nipple is
aligned correctly.
Check the secure connection by pulling
on the high pressure hose.
몇
Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is consid-
ered non-drinkable.
Caution
Always connect the system separator to the
water supply, never directly to the appliance!
Note:
Impurities in the water can damage the
high-pressure pump and accessories. For
protection, the use of the KÄRCHER water fil-
ter (optional accessory, order no. 4.730-059)
is recommended.
Observe regulations of water supplier.
For connection values, see type plate/techni-
cal data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Mini-
mum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
Screw the supplied coupling element to
the water connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Before Startup
Install wheels
Install the storage for hand-spray gun
Install the storage hook for the mains con-
nection cable
Install the transport handle
Install the dosage regulator for detergent
Install the high pressure hose drum
Connect the high pressure hose to the
hand spray gun
Water supply
Water supply from mains