English
11
When the appliance is delivered, the HP hose
and trigger gun are not attached, this prevents
buckling. Please mount these before using the
appliance for the first time.
Î
Push out the safety clip in the trigger gun us-
ing e.g. a small screwdriver.
Î
Join HP hose and trigger gun together.
Î
Push clip in until it engages and check that it
is securely fastened by pulling on the HP
hose.
Î
Remove cable tie and unroll HP hose
The device is not suitable for being op-
erated in the drinking water network. A
suitable system separator as per EN
12729 type BA is needed to operate it
on the drinking water network..
For connection values, see type plate/technical
data.
Observe regulations of water supplier.
Î
Use a fibre-reinforced hose (not included)
with a standard coupling: - Minimum diame-
ter, 1/2 inches (13 mm). - Minimum length,
7.5 m.
Î
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Î
Push the water supply hose onto the cou-
pling unit, then connect it to the tap.
몇
Caution
Never operate the high-pressure cleaner when
the tap is turned off as dry running will damage
the HP pump.
If the water supply is not clean, the Kärcher water
filter must be used (special accessory - order No.
4.730-059).
When fitted with the appropriate accessories,
this high-pressure cleaner can draw in surface
water, e.g. from water butts or ponds (max. suc-
tion height 0.5 m).
Î
Use the Kärcher water filter to protect the HP
pump and accessories (special accessories,
order no. 4.730-059). This filter removes dirt
from incoming water.
Î
As the standard coupling system is not suita-
ble for use in suction mode, the Kärcher suc-
tion hose with integrated filter should be used
instead (special accessory, order no. 4.440-
238) and suspended inside the water butt.
Î
Remove air from appliance before operation:
Switch on the appliance when the HP hose is
not connected and run it until the water which
discharges from the HP outlet is free of bub-
bles. Switch off appliance and connect HP
hose.
Note
: Fill suction hose with water before use,
this will help ventilate the pump of air.
Î
Screw HP hose on to HP outlet on appliance.
Î
Push the appropriate spray lance on to the
trigger gun and fasten it by turning it to the
right through 90°.
Î
Open tap.
Î
Plug in mains plug.
Î
Set main switch to “I/ON”.
Î
Press safety catch on the trigger gun to re-
lease it and pull lever.
몇
Risk of injury
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Carrying out the most common cleaning tasks.
The work pressure can be stagelessly regulated
between "Min" and "Max".
Î
Release the lever on the trigger gun.
Î
Turn the spray lance to the desired position.
For strong contaminations.
Initial start-up
Water supply
Water supply from mains
Drawing in water from open reservoirs
Start up
High pressure operation
Spray lance with pressure regulation
Spray lance with dirt blaster
