English
HDS 796 CW
7
Intended use
Cleaning of: Machines, vehicles,
structures, tools, facades, terraces,
garden implements, etc.
*
Engine cleaning is only to be
performed in areas provided with
oil separator.
*
Heed appropriate safety
regulations for use at petrol
stations or in other hazardous
environments.
Working with high-pressure
nozzle
Spray angle is crucial to efficiency of
high-pressure jet.
Use is normally made of 25°fan jet
nozzle (included).
Recommended nozzles, available as
accessories
–
For stubborn dirt 0°full jet nozzle
–
For delicate surfaces and slight
contamination 40°fan jet nozzle
–
For thick layers of stubborn dirt dirt
blaster
–
Nozzle with variable spray angle,
for adaptation to various cleaning
tasks variable-angle nozzle
Cleaning
*
Set pressure/temperature and
cleaning-agent concentration in
line with surface to be cleaned
*
Always start by directing high-
pressure jet from a good distance
at object to be cleaned to avoid
damage caused by excessive
pressure.
Recommended cleaning method
Loosen up dirt:
Spray on cleaning agent sparingly
and allow to react for 1...5 min (do
not allow to dry on).
Remove dirt:
Spray off loosened-up dirt with high-
pressure jet.
Operation with cold water
Removal of slight contamination and
rinsing
e.g.: Garden implements, terrace,
tools, etc.
Set operating pressure as required
Set selector switch to "I"
Operation with hot water
*
Danger of scalding
We recommend the following
cleaning temperatures
–
Slight contamination 86-122°F
–
Protein soiling, e.g. in foodstuffs
industry max. 140°F
–
Motor vehicle cleaning, machine
cleaning 140-194°F
Set selector switch to desired
temperature
AFTER EVERY OPERATION
Following operation with cleaning
agent
–
Set cleaning-agent regulator to "0"
–
Set mode selector switch to "I"
–
Actuate handgun and flush unit for
approx. 1 min
Stopping machine
–
Set mode selector switch to "0"
–
Shut off water supply
–
Briefly switch on pump with
selector switch (approx. 5 sec.)
–
Make sure hands are dry when
pulling power plug out of socket
–
Detach water connection
–
Actuate handgun to depressurise
unit
–
Secure handgun (Fig. 7)
–
Engage spray lance in cover
holder
–
Roll up high-pressure hose and
cable and place in compartment
*
Take care not to kink high-
pressure hose and cable!
Frost will destroy unit if water is not
drained off completely!
Store unit in a frost-free location
Take unit out of service if frost-free
storage is not possible.
SHUTTING DOWN
In the event of lengthy periods of
non-use or if frost-free storage is not
possible:
–
Drain unit or flush with anti-freeze
–
Drain cleaning fluid tank
Draining unit
–
Unscrew water supply hose and
high-pressure hose
–
Unscrew supply line at boiler base
and allow heating coil to drain
–
Run unit for max. 1 min until pump
and lines are empty
Flushing unit with anti-freeze
–
Use commercial grade antifreeze
–
Observe handling instructions of
antifreeze manufacturer
–
By this means, a certain degree of
corrosion protection is achieved.