Kärcher HD 7/17-4 Cage, User Manual

Page: 14 / 52

– 3
 Read the oil level display when the de-
vice is not running. The oil level must be
above the two pointers.
 Cut off tip of oil container cover
 Install nozzle with nozzle screw on the
spray pipe/nozzle adapter.
 Connect the spray lance/nozzle adapter
to the hand spray gun.
 Fasten the high pressure hose to the
high pressure connection.
몇
Warning
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
The minimum fuse rating required at the sock-
et outlet is (see technical specifications).
The appliance should always be connected
to the electrical mains using a plug. It is for-
bidden to permanently connect the appli-
ance to the power supply. The plug is only
for mains separation.
Check the power cord with mains plug for
damage before every use. If the power cord
is damaged, please arrange immediately
for the exchange by an authorized custom-
er service or a skilled electrician.
The plug and coupling of the extension ca-
ble used must be watertight.
Use the extension cord that has an ade-
quate cross-section (see "Technical Data")
and unwind it fully from the cable drum.
Unsuitable extension cables can be haz-
ardous. Only use extension cables out-
doors which have been approved for this
purpose and labelled with a sufficient cable
cross section:
For connection values, see type plate/tech-
nical data.
몇
Warning
Observe regulations of water supplier.
For connection values refer to technical
specifications
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 1“) to
the water connection point of the appli-
ance (such as the tap).
Note
The supply hose is not included.
 Open the water supply.
 Install the suction hose (order no.
4.440-270.0) to the water connection.
 Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Repeat
the procedure for a couple of times.
 Switch off the appliance and fit the noz-
zle again.

Danger
If the appliance is used in hazardous areas
(e.g. filling stations) the corresponding
safety provisions must be observed.
The jet must not be directed at other per-
sons or directed by the user at him/herself
to clean clothing or footwear.
몇
Warning
Clean engines only at places with corre-
sponding oil separators (environmental
safety).
Risk of blocking. Place the nozzles in the
accessory compartment with their joint
pointing upward.
Start up
Check oil level
Activate deaeration of oil container
Attaching the Accessories
Electrical connection
Water connection
Connection to the water supply
Drawing in water from open reservoirs
Operation
14 EN