Kärcher FC 3d Cordless, Instruction Manual

Page: 27 / 96

– 10
quet, enamelled tiles, Linole-
um).
 Do not use the appliance for
cleaning of carpets or carpet-
ed floors.

Do not use the appliance over
the floor grilles of convector
heaters. The appliance is not
able to take in the water dis-
charged when used above
grilles.

In case of longer breaks in
operation and after use,
switch off the device at the
main switch / device switch
and pull the charger’s mains
plug.
 Do not operate the appliance
at temperatures below 0 °C.
 Protect the unit from rain. Do
not store outside.
Illustration
 Insert handle into the basic unit as far as it goes un-
til it engages audibly.
The handle must sit snugly into the appliance.
Illustration
 Place the device in the parking station for safe stor-
age.
Illustration
 Screw the cleaning rollers onto the threaded rod up
to the mechanical stop.
 Pay attention to the colour-codes on the inside of
the roller and roller holder on the appliance (e.g.
blue should match up with blue).
 After the installation, check to ensure that the
cleaning rollers sit snugly.
Note
Illustration
The appliance can be loaded in operational condition or
with the handle removed (for stowage/storage).
Illustration
 Plug the charging cable of the charger into the
charging socket on the device.
 Plug the mains plug of the charger into a power out-
let.
Illustration
 The LED indicator lights display the battery's cur-
rent charging state.
 All 3 LED indicator lights flash from bottom to top
when charging a completely empty battery.
 The lowermost LED lights up continuously when
the battery is 1/3 charged, the two upper LEDs con-
tinue to flash.
 When the battery is 2/3 charged, the two lower
LEDs light up continuously, the uppermost LED
continues to flash.
 After the battery has been fully charged, the 3 LED
indicator lights will continue to light constantly for
60 minutes. After this time, the LED indicator lights
go out.
Illustration
 Once the battery is charged, pull the mains plug out
of the socket and the charging cable out of the
charging socket.
Illustration
 Place the device in the parking station.
Illustration
 Grasp the fresh water tank by the recessed grip
and remove it from the device.
Illustration
 Open the tank cap and turn it to the side.
Illustration
 Fill the fresh water tank with cold or lukewarm tap
water.
 KÄRCHER detergents/care agents can also be
added to the fresh water tank as required.*
 Do not exceed the "MAX" marking when filling.
 Close tank lock.
Description of the Appliance
1 ON/OFF switch
2 Handle
3 Wall anti-slip handle
4 Strap handle
5 Handle release mechanism
6 Fresh water tank
7 Fresh water tank recessed grip
8 Charging socket
9 Waste water tank
10 Recessed grip cleaning roller
11 Cleaning rollers
12 Floor head cover
13 Floor head cover lock
14 Battery indicator
15 Charger with charging cable
16 Parking station
17 Roller storage
18 * Detergent RM 536 30 ml
Assembly
Commissioning
Installing the rollers
Charging process
Fill fresh water reservoir
27 EN