-
3
Abrasion and dirty wash cards can cause
residue on the reader head.
Moisten the cleaning card with alcohol.
Reinsert the card into the wash card
reader several times.
Check the function of the wash card
reader.
–
Only use accessories and spare parts
which have been approved by the
KÄRCHER. The exclusive use of origi-
nal accessories and original spare parts
ensures that the appliance can be oper-
ated safely and troublefree.
–
At the end of the operating instructions
you will find a selected list of spare
parts that are often required.
–
For additional information about spare
parts, please go to the Service section
at www.kaercher.com.
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
Troubleshooting
Malfunctions at coin mechanism
Fault
Possible cause
Remedy
By whom
Malfunctions be-
low 0°C.
Heater defective.
Heater resistors must be warm, otherwise, call
customer service.
Operator
Wash cards are
pulled in and then
rejected, even
though the "Start/
Stop" key is illu-
minated.
Wash card inserted incorrectly.
Insert the wash card with the arrow on top and
pointing into the direction of the wash card read-
er.
Operator
Wrong station code on the wash card or wash
card issued by different wash station.
Use a different wash card.
Operator/Cus-
tomer Service
Wash card is defective.
Reader is dirty.
Clean the reader (see "Cleaning the reader").
Operator
Wash cards are
pulled in even
though the "Start/
Stop" key is not il-
luminated.
Indicator lamp is defective.
Replace the light bulb.
Customer Ser-
vice
The "Start/Stop"
key is not illumi-
nated; wash card
can be inserted
manually.
Washing station is switched off
Switch the washing station on.
Operator
Fuse in the wash card reader defective.
Replace the fuse.
Customer Ser-
vice
The "Start/Stop"
key is not illumi-
nated; wash
cards are ejected
back out.
The signal reads "ready to wash" or the red
traffic light of the washing station not on even
though the system is ready to operate.
Reset the washing station. Observe the operat-
ing instructions for this. Call customer service if
necessary.
Operator/Cus-
tomer Service
Cleaning the reader
Spare parts
Warranty
9
EN
Summary of Contents for CR 213
