Kärcher BR 40/25 C Bp Eco Pack, Manual

Page: 24 / 380

– 8
4 Vacuuming
Suck in the dirt fleet.
5 Polishing
Polishing the floor without the applica-
tion of liquid.
The battery control display shows the
charging status of the batteries when the
charger has been connected:
Note:
The appliance is switched off automatically
if the battery has been fully discharged
(battery indicator is red). You can restart
the device only after you have fully charged
the battery.
You can acquire additional sets of batteries
to avoid the waiting time when the batteries
are getting charged. You can then replace
the empty battery set in the appliance by a
charged set of batteries.
Note:
The spare battery set must show a mini-
mum voltage of 25.8 V when you connect it
to the device. If the voltage is lower, the
deep discharge protection in the electron-
ics prevents a start-up of the device. In this
case, the battery set must be charged com-
pletely.
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
 Release the wing nuts.
 Turn the vacuum bar.
 Turn the vacuum bar.
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
 Release the wing nuts.

Tilt the vacuum bar.
 Tighten the wing nuts.
 Turn the running gear to the front with
your foot.
 Reducing the speed: Turn the button in
"–" direction.
 Increasing the speed: Turn the button in
"+" direction.
Battery control display
40-100% glows green
20-40% glows yellow
0-20% slowly blinks red
empty glows red
Spare batteries
Setting the Vacuum Bar
Oblique position
Inclination
Setting the Advance Speed (Only
BD Model)
24 EN