![background image](http://html1.mh-extra.com/html/karcher/bg-282037/bg-282037_operators-manual_3625441007.webp)
9.800-083.0 • Rev. 01/08
7
PRESSURE
W
ASHER
OPERA
T
OR’S MANU
AL
STe P 1: Attach the handle to the
frame of the pressure washer. Note:
It may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
STe P 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
STeP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
STeP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STeP 6: Release the coupler col-
lar and push the nozzle and the
collar until the collar clicks or locks.
Pull the nozzle to make sure it is
secure.
STe P 7: Connect high pressure
hose to pump discharge fitting.
Push coupler collar forward until
secure.
STe P 5: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
STeP 8: Connect garden hose to a
clean cold water source and open
supply valve completely. NEVER
use hot water.
ASSeMBly INSTr UCTIONS
STeP 9: Connect the garden hose to pump water inlet.
Inspect inlet screen. CAUTION: Do not run the pump
without water or pump damage will result.
Alignment
Holes
Handle
frame
Assy.
Carriage
Bolt
Nut
Studs
Nut
Hose/Spray Gun
Storage Bracket
Safety
latch
Spray
Gun
High Pressure
Hose
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Pump
discharge
fitting
High Pressure Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler
Collar
Bolts
Washer
Inlet Screen