Karassn KS-858G, User Manual

Page: 8 / 31

Connection picture 2 . Wired zone line-connection diagram
AUX
C
Z1 C
+ 1 2 V GND ALARM TA MP ER
+ -
2
.
2K
AU X
C
Z 1 C
+ 12V GN D ALARM TAMPER
+ -
AU X
C
Z1 C
+ 12V GND AL AR M TA M PE R
+ -
Line-connection
ends of alarm host
2 . 2K
Normal Open End with resistance Normal Close End with resistance
Normal Open End/ Normal Close
End without resistance
Line-connection
ends of alarm host Line-connection
ends of alarm host
Line-connection ends of detector Line-connection ends of detector Line-connection ends of detector
4.2.10 Telephone line connection
PHONE is the interface of telephone incoming line. LINE is extension interface. When alarming, in
order to make alarm host reporting the alarm information to the manage center and user, LINE
i n t e r f a c e s s h o u l d b e c o n n e c t e d w i t h t e l e p h o n e i n c o m i n g l i n e . E x t e n s i o n a n d o t h e r
telecommunication equipment can be connected with PHONE interface. But don't oppositely connect
with incoming line. They should be connected as
Connection picture 1.
4.2.11 Anti-tamper line connection
TAMPER&C is the anti-tamper zone interface. It can be set two switches on the case. One is to avoid
opening the cap illegally; the other one is to avoid moving or dissembling the alarm host.
The install steps of anti-tamper switch
①
Adjust the anti-tamper switch in the right-under corner of case. As to the switch used to prevent
alarm host dissembling, its short-circuit end should be put through the small hole under board of
case. As to the switch used to prevent cap opening, short-circuit end should be put to outer case.
②
concatenate both ani-tamper switches, and then connect the line end with TAMPER&C interface.
4.3 System Debugging
Firstly, check if all lines are connected correctly, next, connect with battery, and cover the case cap.
Then connect with AC power to program. Lastly, test sytem to check if all detector fittings can work
normally and can communicate normally with alarm host or if the alarm host correctly performs all
alarm functions.Then the system installation is finished.
4.4 SIM card installation precautions
Please refer o the alarm host wiring diagram for the installation direction of the SIM card.
①
When installing the SIM card, do not touch other components on the PCB to avoid damage to the
alarm host due to static electricity and affect the normal use of the product.
②
Pulling the SIM card with power will cause permanent damage to the SIM card! Please remember to
unplug the AC power plug and backup battery plugs before installing the SIM card.
③
Ensure that this SIM card has a certain balance of funds, which is used to dial the alarm call or pay
the fee generated when sending the SMS. If you need to connect to the APP or network central
monitor software, the SIM card needs to open the data service.
④
Please try to choose a local SIM card with good GSM network signal. The quality of the GSM
network signal directly affects the reliability of the communication module.
⑤
Be sure to install the GSM antenna and be sure to tighten the screws on the SMA plug, Because the
installation of GSM antenna directly affects the signal strength and power consumption of the
communication module.
-6-