3) Arm/Disarm through timer.
4) Arm/Disarm through remote telephone with user code or master code.
Note: the user code Arm/Disarm is only for corresponding partition. Master coder is for all partitions
Note: During Arm operation, the sound “Bi- Bi-”means Arm, the Arm indicator light will be on and the
corresponding zone will enter arm state. For the delay Arm zones, the panel won't enter arm state until
delay time expired. During the delay time, there is a sound “Bi-” very two seconds to alert users to
leave before delay time arrive.
5)Arm/Disarm through APP.
Enter the user master password to control all partitions of the alarm host to Arm/Disarm; or enter the
common user password to control the corresponding partition list.(Please refer to "APP Programming
Instructions" for specific operations.)
6.4 Manual bypass zone and bypass zone recovery
Manual bypass zone: Press
［
Set
］
+
［
User code
］
+
［
*
］
+
［
OK
］
+
［
Zone number
］
+
［
OK
］
to
bypass zones. The zone number can be entered in one or more digits, that is, one or more
corresponding zones can be bypassed.
Bypass zone recovery: Bypass zone is automatically recovered after disarm operation.
Note: When the wired zone is bypassed, it cannot be armed by the keyboard of the alarm host, but it
can be armed by wireless remote control and APP etc.
6.5 Alarm operation
1). Intrusion alarm
The zone attribute in “Intrude Alarm or Perimeter alarm”, they won't activate until alarm
host
in Arm
state. So don't forget to ARM the alarm system before you leave the place.
2) Emergency Alarm
Press key for emergency help in urgent situation, the alarm activate by emergency key will dial
all alarm phone numbers and activate on-site siren.
3) Duress alarm
When you are under duress by robber, press the duress code. The alarm system will be disarmed, but
send duress information through phone dialer.
Note: If your system setup is in delay alarm state, the duress alarm will delay. During the time, the
host will be Di- Di- every two seconds. You can disarm system.
6.6 When you receive alarm
1)ADEMCO alarm center processing automatically
2)Users processing
When alarm host dials the phone number you set. It plays the recorded message your stored. And
give you 5 seconds after displaying message. During 5 seconds, you are able to press 5#
、
4#
、
2# or 0# on your telephone or mobile phone.
Press 5# to display message you stored repeatedly.
Press 4# to listen to 30 seconds sound from alarm host location. During the time, any operation is
ineffective. You are able to enter other commands (see appendix 4) after 30 seconds. If there are not
any operations in 30 seconds, the system will dial next phone number your set.
Press 2# to deactivate alarm and disarm the alarm host. It will not dial other phone numbers you
stored any more.
Press 0# to exit this call, and dial next phone number your stored. But system will dial this number
later in turn.
-22-
Summary of Contents for KS-858G
Page 31: ...V1 0 P M...
