CAN RANGER III INSTALLATION
6
CABLES
NOTE: PLEASE REMOVE PIGTAIL PLUGS FROM REMOTE, BA, and
BB CONNECTORS BEFORE PROCEEDING. THESE WILL NOT BE
NEEDED IF MATTING CONNECTORS ARE SUPPLIED WITH CRANE
HARNESS.
1.
Beginning at the lower access panel, feed the main harness
with the 6 and 12-position connectors first, behind the valve
assembly, around the back of the actuator assembly, and up
toward the arm (FIG. 8 & 9)
2.
Plug the 6 and 12-position connectors into the control module
(FIG. 11). Leave enough slack on the cable so that the arm can
pivot freely
3.
Pull up the cable with the connector marked CA and route it
through the upper hole in the turret (FIG. 10)
4.
Connect each of the actuator cables to one of the 4 jacks
provided on the Y-cable from the receiver. Loop any extra cable
and bundle these neatly, tying them to a convenient point (FIG.
4).
FIG. 8
FIG. 9