CAN RANGER III INSTALLATION
11
Assign Actuators Main Screen
After selecting this by pushing
SET, the receiver’s LCD will
walk the operator through the
procedure. The basic idea is
that all actuators need to be
disconnected from the
system. This means both
disconnecting the wire
cable and disconnecting
the mechanical linkage
from the shaft of the
actuators. Next, one by one
the actuators are connected
to the system. Each time the
operator tells the receiver
which actuator was added,
the receiver will assign that
actuator the appropriate
function. When an actuator 1
is selected, the following
screens will be displayed:
Assign Actuator 1 Screen
After <SET> is pressed:
Calibration Start Screen
Calibration Completed Screen
Things to keep in mind while
concerning Actuator IDs:
