8
7.0 INSTALLATION INSTRUCTIONS
7.1
KPT-2200 INSTALLATION
1.
RECOMMENDED:
Select the electrostatic
film from the box and install it on the front
windshield in the recommended position as
shown below. Please wipe the glass before
installation and push out the bubbles between
the static film and the glass before installation.
2. Remove the protective film from the KPT-2200 and position the DVR in the
middle of the electrostatic film (optional). Press down on the base of the bracket
by hand for 30 seconds to ensure that the sticker adhesive is attached to the
electrostatic film, and adjust the camera by rotating the barrel until it is
capturing the entire road.
3. Run the KPT-2200 cable along the top of the
front windshield through the A pillar and around
and under the storage compartment of the
passenger seat to the car's 12/24V adaptor
port. Connect the 12/24V adaptor to the car
power.
