18
Applying Power
1. After all wiring is completed, apply power to the KT-315.
2. Connect the battery leads to the battery.
3. Then, connect the AC transformer.
NOTE:
Do not connect the power until all wiring is completed.
Assigning the KT-PC4216 Module
Follow the Instructions below for assigning and programming your KT-PC4216 module.
1. Establish communication between EntraPass and the controller.
2. Remove the tamper switch wire (or only the wire if tamper switch is not used).
3. A serial number, the type of module and on which controller it is connected should be displayed on the screen.
4. From the EntraPass user interface, go to the controller definition window and select the functionality of the module and
enter the serial number in the appropriate field (refer to
Chapter 4, Defining Devices
of your
EntraPass Reference Manuel
for more details).
NOTE:
Do not forget to reconnect the tamper switch (or the wire, if there is no tamper switch).
NOTE:
If you are using a KT-PC4204 in “repower” mode on the same loop, do not use the first relay of the KT-PC4216.
KT3-LCD - Kantech LCD Time & Date Display Module
KT3-LCD Introduction
The KT3-LCD module is an LCD readout module with integrated keypad
which provides date and time via a 32-character liquid crystal display.
KT3-LCD Specifications
•
Connects to control panel via 4-wire Combus
•
Current draw: 50 mA (from Combus)
•
Input status (green), AC Fail (red) and Trouble (yellow) status lights
Unpacking the KT3-LCD
The KT3-LCD package includes the following parts/items:
•
One KT3-LCD keypad
•
Four mounting screws
Mounting the KT3-LCD
The keypad should be mounted where it is accessible to designated points to entry/exit. Once a dry and secure location is
selected, perform the following steps to mount the keypad:
1. Remove the keypad back plate by loosening the screw located at the base of the unit.
2. Secure the keypad back plate to the wall in the desired location. Use the included screws.
Wiring the
KT3-LCD
Before beginning to wire the unit, ensure that all power (AC transformer and battery) is
disconnected from the control panel.
To complete keypad wiring, connect the four Combus wires (Red, Black, Yellow and
Green) to keypad terminals R,B,Y and G.
Applying Power
1. Once all wiring is completed, turn the controller on.
2. Connect the battery leads to the battery.
3. Connect the AC transformer.
NOTE:
Do not connect the power until all wiring is completed.
Assigning the KT3-LCD Keypad
Once all wiring is completed, the module must be assigned to the system. To assign the module, perform the following steps:
1. Establish communication between EntraPass and the controller.