DN1315-1007
2
KT-300 Door Controller Installation Manual
KT-300 Compliance Specifications
FCC & IC Compliance
This device complies with FCC Part 15, Subpart B:2009. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received including interference that may cause
undesired operation. This class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment
Regulations. The KT-300 is also compliant with EN55022:2006, Class B.
Compliance Notice
This product is in conformity with EMC Directive 2004/108/EC based on results using harmonized standards in accordance with
article 10(5) and LVD Directive 2006/95/EC based on results using harmonized standards. This product is labeled with CE mark
as proof of compliance with the above mentioned European Directives.
CE & C-Tick Compliance
•
EN50133-1: Alarm systems - Access control systems for use in security applications: system requirements.
UL Compliance Notice
To comply with UL listings, the following requirements must be met:
•
Use of a UL listed computer
•
Use of UL listed readers (Wiegand 26 and 34 bits, mag stripe 26 and 34 bits, have been tested and found to comply)
•
Use of a UL recognized tamper switch on every housing cabinet for the KT-300
•
Do not use the SmartLink option
•
Use the Kantech IP Link Enhanced Ethernet Device
•
Us the KT3-LCD module on each KT-300 controller (should be installed near the controller)
•
Do not use a 220 V transformer (not UL listed)
•
Use only UL listed cables
•
Use only UL listed adaptors
•
Use only a UL listed transformer such as Kantech TR1640P/UL or DSC PRD1640
•
Use Kantech BD7-12 battery
•
The KT-CAB3000LDR and KT-CAB4000LDR have been evaluated by UL as alternate enclosures.
NOTE:
Backup battery provides operation of up to 12 hours but has been tested only 4 hours per Section 33 of UL294, fifth
edition.
NOTE:
All circuits are power limited.
UL 1076 Standard:
The following Kantech readers were validated by UL for the UL 1076 standard: P225W26, P225KPW26, P225KPXSF,
P225XSF, P325W26, P325KPW26, P325XSF, P325KPXSF, and P600.