11
11
11
11
11----4 Adjusting the movable knife left to right
4 Adjusting the movable knife left to right
4 Adjusting the movable knife left to right
4 Adjusting the movable knife left to right
Movable knife C should pass clearance B between
spreader A and the left needle. Loosen screw H for
bracket G. Adjust movable knife C while checking it
does not touch spreader A or the left needle.
11
11
11
11----5 Adjusting the movable knife front to back
5 Adjusting the movable knife front to back
5 Adjusting the movable knife front to back
5 Adjusting the movable knife front to back
The movable knife should hook the top cover thread
when the movable knife returns home.
Loosen screws J on movable knife installation base I.
Set the clearance between hook end D of movable knife
C and the top cover thread at approximately 1mm.
11
11
11
11----6 Adjusting the height of the movable knife
6 Adjusting the height of the movable knife
6 Adjusting the height of the movable knife
6 Adjusting the height of the movable knife
When the movable knife is at the bottom of its travel,
hook point X of the movable knife should be aligned
with the top surface of the spreader.
Adjustment is made by moving stoppers B (see the
illustration on the previous page).
Then tighten screws F when bracket E is in the lowest
position.
< Note >
Turn off the motor, position the fabric under the presser
foot and then adjust by hand.
