KANSAI SPECIAL DFB Series, Instruction

Page: 16 / 37

13
【
4
】
LUBRICATION
4 - 1 O i l
Use Kansai Special’s genuine oil.
(Part No. 28-611)
4 - 2 T o f i l l t h e m a c h i n e w i t h o i l
Remove oil pot A.
Fill the machine with oil until the oil level is at the
top line (see H in the illustration) on oil gauge C.
After the first lubrication, add oil so that the oil level
will be between H and L.
After filling the machine with oil, run the machine
to check the oil is splashing onto oil pot A.
4 - 3 R e p l a c i n g t h e o i l a n d t h e f i l t e r e l e m e n t
To extend machine life, be sure to replace the oil
after the first 250 hours of operation.
To replace the oil, follow the procedures below.
1. Remove the V belt from the motor pulley and
then remove the machine from the table.
2. Remove screw D and then drain the oil.
Be careful not to stain V belt with the oil.
3. After draining the oil, be sure to tighten screw
D.
4. Fill the machine with oil by referring to 4-2
shown above.
If filter element E is contaminated, proper oiling may not be performed.
Clean the filter element every six months. If just a little or no oil flows out from the
nozzle with the proper amount of oil in the machine, check the filter element.
To clean the filter element, remove oil reservoir.