KANSAI SPECIAL DFB Series, Instruction

Page: 36 / 37

33
1 7 - 2 A d j u s t i n g t h e r u f f l i n g a r m s e t s
The length of the ruffling arm should be about
99.4mm by loosening screw A tighten screw A after
that adjustment. See Fig 2.
The ruffler blade B should be parallel with the
needles and the needle plate at same time and then
tighten C screw carefully. The ruffling arm should
be attached the driving shaft F and tighten screw D
and then tighten screw E. When the ruffler blade
B get the nearest to the needle, the tip of the ruffler
blade be 1mm left-side from the center of needle by
loosening nut L. See Fig 3, 5.
■
The ruffler blade B and the low stripper blade
should be the clearance I by loosing screw H and
move the stopper plate G to left or right.
When the stopper plate G is right, the clearance
become wide. On the other hand, when the stopper
plate G is left, the clearance become narrow.
The adjustment for the movementum of the ruffling
arm should be made by loosening screw M.
When the distance K is narrow, the movement
become big. On the hand, when the distance K is
wide, the movement become small. See Fig 5.
For exsample, the distance of movement position is
35mm. See Fig 4.
F i g 2
F i g 4 F i g 3
F i g 5