Kanomax 6333, User Manual

Page: 19 / 40

17
2-7．Connecting the Probe Fixing Jig (Accessory)

This probe fixing jig is for Probe 0976-03 and 0976-04, 0976-13, 0976-14 only.
Do not use this jig for any probe other than the two probes above. It may cause a
malfunction or damage.
Follow the steps below to attach/remove the probe to/from the probe fixing jig.
When you attach or remove the probe, do not allow the air velocity sensor of the probe
to touch the probe fixing jig or surrounding objects.
Do not touch the air velocity sensor of the probe with your hand. It may cause a
malfunction or damage.
■ Attaching the Probe
Place a part of probe outlined in red line as shown in the figure below on the probe
fixing jig and push the probe until it clicks.
■ Removing the Probe
As the figure below shows, move the cable near the probe fixing jig to the direction of
the air velocity sensor (left), and hold a part of probe outlined in red line and remove
the probe. (right)
The mounting angle can change due to the probe tension.
If its angle changes, adjust the mounting angle if needed.