7.2 Other Function Settings
You can configure the baud rate, measurement units, data output parameters using the bit settings on the screen (Soft
Dip Switch). Once the setting is stored, it will not be lost even if the instrument is turned OFF because of the back-up
batteries.
7.2.1 Setting Procedure
DISPLAY
PROCEDURE
Turn the power OFF once. Then turn the power back ON pressing
key. Keep holding down
key until you see a display
like the one shown on the left.
The “b0” on the left indicates the bit number, and “01” on the right
shows the bit status. (See “7.2.2 Dips Switch Setup Chart” in the next
page for the details on bit number and bit status.)
Using
keys to select the bit status. Press
key to
save the setting and move to the next bit number. (After the bit number
reaches 9, it will go back to 0.)
After completing all of the bit number settings, press
key to
return to the Normal Measurement screen.
7. Other Settings
29
Bit number is zero
Shows the bit status
m/s
