5. Measuring AVG, Max and Min Value
***
Calculation Mode ***
Calculation Mode calculates the maximum, minimum, and average value of the stored data.
If there are no stored data, you must store measurement data first referring to “4. Saving and Deleting Measurement
Data” in page 14.
The calculation is performed using all of the stored measurement data. (You cannot select certain data and perform
calculation.)
DISPLAY
PROCEDURE
(1)
<Normal Measurement Display>
Press
key on the Normal Measurement screen (Measurement
Mode) to go to the Calculation Mode. (You can perform this procedure
in any measurement mode of measuring Air Velocity, Air Temperature
and Pressure.)
In the Calculation Mode every time you press
key, the
display changes as follows:
(2) Average Value Display (Avg)
→
(3) Max Value Display (Max)
→
(4) Minimum Value Display (Min)
→
(5) Stored Measurement Data
Display
→
(1) Normal Measurement Display
(2)
<Average Value Display>
When the average value shows up, the total amount of stored
measurement data is displayed at the bottom.
In this mode every time you press
key, the average value of
the followings is displayed as follows:
Air Temperature
→
Pressure
→
Air Velocity.
(3)
<Maximum Value Display>
When the maximum value shows up, the total amount of stored
measurement data is displayed at the bottom.
In this mode every time you press
key, the maximum value
of the following is displayed as follows:
Air Temperature
→
Pressure
→
Air Velocity
(4)
<Minimum Value Display>
When the minimum value shows up, the total amount of stored
measurement data is displayed at the bottom.
In this mode every time you press
key, the minimum value of
the following is displayed as follows:
Air Temperature
→
Pressure
→
Air Velocity
5. Measuring AVG, Max and Min Value
17
Avg
m/s
Min
m/s
Average Value Mark
Total amount of stored measurement data
Minimum Value Mark
Maximum Value Mark
m/s
Max
m/s
