Technical manual
KANMED Operatherm OP3
Page
27
of
34
With the bottom plate removed, the power board can be removed without removing any of the
other boards. In this case,
carefully
disconnect the cables (4 pcs) from the power board and the
earth pin for easier removal of the circuit board. Do not pull directly on the cables! Use a screw
driver to carefully pry the connector locking device open. Then pull the connectors straight up.
Remove the 4 screws that hold the circuit board in place.
Carefully pry the connector locking device open Slide the PC board to the side and carefully
remove it.
If the Display assembly or the main board needs to be removed, pls proceed as follows.
1. Cut the front rubber open
2. Peel it off.
