KANEXPRO
MX-HDBASE6X6-4k
12 |
P a g e
4.2.1
Usage of IR Remote
①
Standby button, press it to enter/ exit standby
mode
②
Input channels, range from 1~4 (buttons 7~8 are
not available), corresponding IR signal switched
synchronously when switching input channels.
③
Menu buttons,
ALL
,
EDID
and
CLEAR
, same
with the corresponding front panel buttons.
Please refer to
4.1 Front Panel Button Control
for
details.
④
: Navigation buttons.
ENTER: Confirm button.
⑤
OUTPUTS (buttons 7~8 are not available)
In normal mode: output channel selection
buttons, each channel has 1 IR IN, 1 HDBaseT, 1
RS232, and 1 AUDIO outputs, and channel 1~4
have HDMI outputs.
In EDID invoking mode: press button 1/2 to
switch among the 5 embedded EDID data
Note:
With this IR remote, MX-HDBASE6X6-4K can be controlled by the built-in IR, the
extended IR receiver connected to the “IR EYE”/”IR ALL IN” and the IR receiver on the
far-end receiver.
4.2.2
Force Carrier
a)
Only if the IR receiver connected to HDBaseT receiver is with IR carrier, can the
received IR signal be transferred to IR OUT port of the matrix.
b)
Only if the IR receiver connected to
IR
ALL IN
port of the matrix is with IR carrier,
can the received IR signal be transferred to IR OUT port of the matrix.
If the IR receiver connected with HDBaseT receiver or IR ALL IN port of the matrix
is not with IR carrier, send the command “%0901.” to enter infrared carrier enforcing
mode
, and then IR signal can be transferred to IR OUT port.
4.2.3
Control Far-end Device locally
Connect an IR receiver to IR IN/ IR ALL IN on the switcher, and use the IR Remote of
far-end device to control the device locally.
1 to 1: (through IR IN)
Summary of Contents for MX-HDBASE6X6-4K
Page 42: ......
