Supplied By www.heating spares.co Tel. 0161 620 6677
KANE450
manual
Page
6
3. USING THE ANALYSER AND ITS FOUR BUTTONS:
Switching ON
the Analyser
Press button to switch the unit ON in fresh air outside the property
about to be tested. This lets the analyser auto calibrate its’ sensors
properly.
On switch on, the analyser beeps four times and displays the fuel
previously selected, the date and time and model number. Its’ bottom line
counts down from 60 until the sensors are ready to use – This normally
takes 20 - 30 seconds but may take longer as sensors get older. If the
analyser will not auto calibrate, its’ sensors need to be replaced or
recalibrated by an authorized repair center.
If the inlet probe is connected to the analyser during its’ countdown the
measured temperature from the inlet probe will be used as the inlet
temperature.
If the inlet probe is not connected and you connect the flue probe’s
temperature plug to the analyser during countdown the measured
temperature from the flue probe will be used as the inlet temperature.
If neither probe is connected during countdown the analyser’s internal
ambient temperature will be used as the inlet temperature.
Switching OFF
the Analyser
Press button to switch the analyser OFF. The display counts down
from 30 with the pump on to clean the sensors with fresh air – If the probe
is still connected, make sure analyser and probe are in fresh air.
Press HOLD / ENTER if you want to stop the countdown and return to
making measurements.
Note: the analyser will not switch off until the CO reading is below
20ppm
Using UP /
DOWN /
ENTER Buttons
Use the UP / DOWN / ENTER keys to change settings (such as time, date
and fuel) when the rotary dial is turned to MENU.
Printing Data
Press and
quickly
release the key to start the analyser printing. The
analyser displays "PRINTING" until this is completed. Press and release
the key again to abort printing.
Make sure the printer is switched on, ready to accept data and its’ infrared
receiver is in line with the analyser’s emitter (on top of the analyser).