Copyright
©
Kanda 2013
3
Make sure you use the correct header on the STK300 board – it is the box header next
to the 9-way D-Type connector and power input.
Power Supply
4) Connect a power supply to the board. The connector type required is 2.1mm barrel,
centre negative or centre positive. It can be 7-12VAC or 9-15VDC, with a current
capacity greater than 300mA.
AVRISP software
Now run the AVRISP software
•
A Green Light should appear at the bottom of the screen with the message ISP
Initialized : Detected Device Atmega128
If a RED light appears on the status line, then check the following
1) The AVRISP is connected to the board as shown above
2) The board is powered
3) AVR appears in Programmer box at top of screen
On/Off
Switch
Power
Connector
RS232
Connector
Programming
Interface
Port Headers
