Nesis
— User’s Manual
6.1
Route Planner
Some user options are not shown on secondary Nesis screen, some options require password
entry before proceeding and some options are available only when correct hardware is de-
tected.
The factory default password is
314
, first three most significant digits of number
π
. The
password was introduced in order to prevent unwanted accidental alteratoins of important
settings.
Figure 26:
Password is required in order to open certain options. Figure shows five digits,
but three digits are enough.
The
Service Settings
require special password, which is specific for each Nesis unit. The
following options are available in the service mode. These options are executed rarely and
require extra care.
The
System Preferences
icon is used to set instrument screen configuration and flight
parameters.
The
Level Adjust
icon is used to adjust the installation specific roll, pitch and yaw
correction angles of the AHRS unit (Airu).
The
Airplane Engine
icon configures the engine related settings and sensors connected
to the engine monitoring unit (Daqu).
The
Tank Calibration
icon starts setup procedure for the fuel level measuring hard-
ware and run procedures required for the fuel tank shape calibration.
The
Sensor Offset Correction
alows
zero
adjustments of several sensors and engine
time.
The
User Mode
icon allows you to switch back to the user specific settings.
6.1
Route Planner
The route planner is used to manipulate routes. The routes may be created, edited or deleted.
Typically, routes are created on ground as a part of the flight planning process.
Note, that you can also use the browse mode of the navigation screen to create the routes.
See section 5.4 starting on page 30.
Figure 27 shows the route planner dialog. It has three logical parts:
The
Cruising speed
indicates your cruising speed. You can change it in the
User
preferences
dialog.
The
Route
list displays existing routes.
Routes can be created, edited, deleted or
reversed.
The
Waypoint
list displays waypoints in the selected route. When the waypoint list is
active, waypoints can be inserted, deleted and reversed.
Version 2.0
33
©
Kanardia
2011
