Kampmann Venkon Series, Assembly, Installation And Operating Instructions

Page: 84 / 92

Venkon
Assembly, installation and operating instructions
84
Parameter Function Standard Min. Max. Unit Venkon
10
P119 Off delay time 0 0 255 sec 0
P120 reserved - - - - -
P121 reserved - - - - -
P122 Relative fan speed increase via contact 2 0 5 - 2
P123 Maximum valve running time 150 0 255 sec 150
P124 Minimum P + I output variation for valve motion (0 to 10) 5 0 100 % 5
P125 reserved - - - - -
P126 Weeks of operation 0 0 255 week 0
P127 Info weeks of operation reached (filter message) 0 52 255 week 0
P128 Reset weeks of operation counter 0 0 1 - 0
P129 Fan speed limiter activation in certain operating modes 0 0 1 - 0
P130 Absolute fan speed increase via contact 2 0 5 - 2
P131 External ventilation, delay time 0 0 255 min 0
P132 Operating level, master password 22 0 255 - 22
P133
Hysteresis for outside temperature for switching between
heating/fan mode
0 0 255 K/10 0
P134
Threshold for outside temperature for switching between
heating/fan mode
0 0 50 °C 0
P135 Enable virtual sensor 0 0 1 - 0
P136 Enable external ventilation 0 0 2 - 0
Tab. 14: Key parameters, standard revision 1.024 from 01.05.2018
12.2 KaController parameter list
Para-
meter Function Standard Min. Max. Unit Comment
t001 Serial address 1 0 207 -
Address in Mod-
bus network
t002
Baud rate
0 = Baud rate 4800
1 = Baud rate 9600
2 = Baud rate 19200
2 0 2 -
t003
Background lighting function
0 = Slow fade in, fast fade out
1 = Slow fade in, slow fade out
2 = Fast fade in, fast fade out
0 0 2 -
t004 Strong background lighting 4 0 5 -
t005 Sensor calibration of KaController sensor 0 60 60 °C
t006 LCD display contrast 15 0 15 -
t007
BEEP setting
0 = BEEP ON
1 = BEEP OFF
0 0 1 -
t008 Password for KaController Parameter menu 11 0 999 -
t009 Minimum settable setpoint temperature 8 0 20 °C
t010 Maximum settable setpoint temperature 35 10 40 °C
t011
Interval of setpoint setting
0 = Automatic setting depending on
PCB (parameterisable, freely programmable)
0 0 2 -