background image

5

Important Safeguards For All  

Electrical Appliances  

•  Fully unwind the power cord before use.
•  Connect only to a 230V or 240V  

power outlet.

•  Do not let the power cord hang over 

the edge of a bench or table, touch hot 

surfaces or become knotted. 

•  To protect against electric shock do not 

immerse the kettle, base, power cord or 

power plug in water or any  

other liquid.

•  The appliance is not intended for use by 

persons (including children) with reduced 

physical, sensory or mental capabilities, 

or lack of experience and knowledge, 

unless they have been given supervision 

or instruction concerning use of the 

appliance by a person responsible for 

their safety.

•  Children should be supervised to ensure 

that they do not play with the appliance.

•  It is recommended to regularly inspect 

the appliance. To avoid a hazard do not 

use the appliance if power cord, power 

plug or appliance becomes damaged in 

any way. Return the entire appliance to 

the nearest authorised Kambrook Service 

Centre for examination and/or repair.

•  Any maintenance other than cleaning 

should be performed at an authorised 

Kambrook Service Centre.

•  This appliance is for household use only. 

Do not use this appliance for anything 

other than its intended use. Do not use 

in moving vehicles or boats. Do not use 

outdoors. 

Misuse may cause injury.

•  The installation of a residual current 

device (safety switch) is recommended 

to provide additional safety protection 

when using electrical appliances. It is 

advisable that a safety switch with a 

rated residual operating current not 

exceeding 30mA be installed in the 

electrical circuit supplying the appliance. 

See your electrician for professional 

advice.

•  Always turn the appliance to the OFF 

position, switch off at the power outlet 

and unplug at the power outlet when the 

appliance is not in use.

•  Before cleaning, always turn the 

appliance to the OFF position, switch off 

at the power outlet, unplug at the power 

outlet and remove the power cord, if 

detachable, from the appliance and 

allow all parts to cool.

•  Do not place this appliance on or near 

a heat source, such as hot plate, oven or 

heaters.

•  Position the appliance at a minimum 

distance of 20cm away from walls, 

curtains and other heat or steam sensitive 

materials and provide adequate space 

above and on all sides for air circulation.

•  Do not remove the Kettle from the 

power base during operation. Ensure the 

Kettle has switched off after the water 

has boiled or reached the selected 

temperature, before removing the Kettle 

from the power base. 

•  Do not move the Kettle while it is  

switched on.

•  Do not overfill the Kettle past the ‘MAX’ 

mark which is indicated inside the Kettle. 

If the Kettle is overfilled, boiling water may 

be ejected. 

•  Do not open the lid during operation.
•  Keep the Kettle clean. Follow the 

cleaning instructions provided in this  

book (page 9).

WARNING:

 Do not 

operate the kettle on an 

inclined surface. Do not 

move the kettle while it is 

switched on. 

WARNING:

 Do not 

remove the lid while water 

is boiling.

Summary of Contents for KSK76 Series













Reviews: