Kambrook KSK76 Series, Instruction Booklet

Page: 8 / 12

7
Using Your Dome Kettle
Before First Use
Remove any packaging material and
promotional labels before using your
kettle for the first time.
It is recommended before the first use
to fill the kettle to the maximum level
with cold tap water, bring to the boil
and then discard the water.
Your kettle will only operate when
positioned on the power base
with the ON/OFF switch in the ‘ON’
position. The kettle will automatically
switch OFF once the boiling cycle has
been completed.
Operation Of Your Kettle
1.
To fill the kettle, remove it from the
multi-directional power base and
pull up on the lid to open. Fill with
the desired amount of water. Do
not operate the kettle without
water. Never fill the kettle above
the ‘MAX’ mark, which is indicated
inside the kettle (Fig. 1). Too
much water could result in water
splashing out of the kettle; too
little water will result in the kettle
switching off.
Fig. 1
2. Ensure that the lid is fit in place
and firmly closed before placing
the kettle on the power base.
3.
Place the kettle firmly onto
the power base and plug the
power cord into a 230V or
240V power outlet.
4. Press the ON/OFF switch to
the‘ON’ position. The power ‘ON’
light will illuminate.
5.
The kettle will automatically switch
OFF once the water has boiled.
Lift the kettle from the power base
and pour the water. Take care to
hold the kettle level, especially
when filled to the maximum level.
To re-boil it may be necessary to
wait for a few seconds to allow
the control to reset.
6.
The kettle should be stored on
its power base when not in use.
The power outlet should be
switched off and the power cord
unplugged from the power outlet
when not in use.
NOTE:
This kettle must only be used
with the multi-directional power
base supplied. Use caution when
pouring water from your kettle as
boiling water will scald. Do not
pour the water too quickly
NOTE:
Never operate the kettle
dry - too little water will result in
the kettle switching off. Do not fill
above the MAX mark as boiling
water may splash out from the
kettle. The ‘MAX’ mark is shown
on the steam tube cap inside
the kettle.