9
To Use the Processing Blade
WARNING:
Blades and
discs are sharp and must
be handled carefully.
1.
Carefully remove the protective
safety storage cover from the
processing blade. The cutting
edge of the processing blade is
extremely sharp, it should only
ever be held by its central plastic.
2.
With the wider opening facing
downwards, place the processing
blade over the centre of Spindle
2. Ensure the processing blade is
pushed all the way down to the
base of Spindle 2 (See Fig. 3).
Fig. 3
NOTE:
ALWAYS store the processing
blade with the protective safety
storage cover provided.
To Use the Stainless Steel
Slicing/Grating/Chipping
Discs
1.
Carefully select the desired
stainless steel disc to be used
(slicing, grating or chipping).
2.
Holding the disc holder, slide the
selected disc (sharp edged facing
upwards) into the disc holder slot.
Push the stainless steel disc into
place until the circle hole at the
end of the disc is directly above
the hexagon shaped hole found
on the disc holder (See Fig. 4).
Fig. 4
3.
Place the assembled disc holder
with stainless steel disc onto
Spindle 2 and push down so that
it falls into place (See Fig. 5).
Fig. 5
NOTE:
The disc holder will not turn
Spindle 2 when Spindle 1 is not
correctly fitted on the drive shaft
of the motor base.
