4
EN
5. Fitting the different sensors.
5.1. Accelerometer.
5.1.1 Positioning on the shoe.
1
2
3
- Slide the lace clip under the laces, lengthwise, on the flattest part of the shoe (inaccurate readings
will occur if its angle from horizontal is greater than 30°);
- Clip the accelerometer (oval capsule) under the rear trough of the lace clip, with the accelero-
meter notch pointing forwards;
- Press the front section of the lace clip and the front of the accelerometer at the same time to lock
the notch of the accelerometer in the clip’s slot;
- Tighten your laces enough to keep the accelerometer in place.
Removing the accelerometer: Press the tab at the front of the lace clip to remove the accelero-
meter.
5.1.2. Positioning in the shoe.
Some models of shoe have a housing, under the insole to
accommodate the accelerometer. In this case, you do not
need the lace clip. You just have to make sure that the accele-
rometer is pointing in the right direction in the shoe’s housing.
It must be positioned with its back pointing upwards (you can
identify this by the ANT+ logo and the battery compartment).
5.2. Heart rate monitor belt (except W 500 SD).
Setting up:
1
2
3
Sensors
Reception cone:
*118.08 inchs