73
33.3
Setting the time
1.
Hold down the
P
button until the time display starts flashing.
2.
Use the
+
or
-
buttons to change the hour, then confirm your choice by pressing the
button. The
minutes will then begin to flash. Use the
+
or
-
buttons to change the minutes, then confirm the
change by pressing
.
3.
The number indicating the day of the week will then begin to flash. Select the number ‘1’ for Sunday,
‘2’ for Monday, and so on, then confirm your choice by pressing
. To exit the parameters menu,
press
P
. Wait for 30 seconds while the information is transmitted.
33.4
Activating/deactivating the flames in manual mode
1.
Hold down the
button until ‘OK’ at the top left of the screen begins flashing.
While holding
down, briefly press
to activate automatic ignition.
Release the two buttons.
‘WARM’, displayed at the top left of the screen, begins to flash, indicating that the request has been
confirmed.
After several seconds, a beep indicates that ignition is starting up and ‘WAIT’ displays on the screen.
After about 20 seconds, the burner ignites.
A second beep confirms the completion of ignition and ‘WAIT’ stops flashing.
The fire is on.
To switch off the fire, hold down the
button for around 2 seconds.
33.5
Adjusting flame height in manual mode
The height of the flames can only be adjusted when the fire is in operation.
1
Press
+
or
-
to display the flame height on the screen, ranging between 8, the highest flames (9
if ECO mode is activated), and 1, the lowest flames.
2
Use
+
or
-
to adjust the flame height as desired. When the button is released, the flame height is
indicated by the number of horizontal bars. The ECO mode has a modulating effect on flame height
(see section 32.6). This mode is activated by setting the flame height to 9 using the
+
button. After
confirming the desired flame height, the display will continue to flash for several seconds while the
request is transmitted to the fire.
33.6
Using ECO mode (position 9) in manual mode
By regularly varying flame height, ECO mode accentuates the user’s comfort as well as the aesthetic appeal of the play of flames,
while at the same time reducing the fire’s heat emission and gas consumption by around 40%. To select this modulating effect, use
the remote control to set the flame height to 9. The double flame icon
will display on the screen.
Summary of Contents for ECO-prestige 75
