Tigertop™ – Installation Instructions
s
p
a
n
S
r
e
n
r
o
C
r
a
e
R
l
l
a
t
s
n
I
w
o
B
r
a
e
R
o
t
p
o
T
p
a
n
S
View from inside top
Snap to bow
Bow
Snap the flaps to the six studs on the rear bow.
Adjust Tension on Top
IMPORTANT:
The following steps are
extremely important to the fit of the top
and will require two people.
Make sure that the top is as warm as possible
before continuing with the installation.
Close the zippers on the Rear Curtain.
Slide the Rear Bow up on the Front
Bow and insert the small bent tab into
the bottom of the four holes in the
Front Bow.
Front
Bow
Insert tab into
bottom hole
Rear Bow
Rub chalk on the snaps on the inside of the top
to mark the stud locations. Have one person pull
down on the Rear Bow while the other person pulls
the fabric down and to the rear to locate the Rear
Corner Studs. The studs should be located 3/4"
below the top of the body.
When you are satisfied with the tightness of the
top, press the snaps against the body. The chalk
will leave marks for the Body Stud locations. Center
punch the marks and drill a 3/32" hole at each
marked location. Install a Body Stud with a #6 x
3/8" Sheet Metal Screw at each location. Snap the
top to the Rear Corner Studs.
If the top is extremely tight, slip the tab
into the bottom hole. The top will loosen
up after a few hours in the sun. Then the tab may
be moved up into a higher hole position.
Locate and Install
the Two Rear Corner
Body Studs on Both
Sides
