Tigertop™ – Installation Instructions
Install Bow Assembly
When drilling in the top
edge of the vehicle body,
check underneath for
wiring for the rear lights. Pull the wiring out of the
way before drilling.
Install Footman Loops
When drilling in the top
edge of the vehicle body,
check underneath for
wiring for the rear lights. Pull the wiring out of the
way before drilling.
Bow
Secure front hole
rst - inside mount
Bow Mount
Front
Secure rear hole
second
5/16-18 x 1" Phillips
Head Bolt
5/16 Washer
5/16 Tapping Plate -
under ledge
It may be helpful to have two people so
that one person can support the bow
halves while they are installed.
Rear point of
measurement
on body
Footman Loop
#10 x 1/2" Oval
Head Phillips Screws
Install the Footman Loops on the rear corners of the
vehicle. Center the loops over the Phillips Head Bolt
on the top, rear corner on each side of the vehicle.
Use the loop as a template to mark, center punch
and drill two 5/32" holes. Install the Footman Loop
with two #10 x 1/2" Oval Head Phillips Screws. Do
this on both sides of the vehicle.
30 3/4" From
Rear Corner
28 3/4" From
Rear Corner
For vehicles without factory bow pockets,
measure 28 3/4" and 30 3/4" along the top edge of
the body from the rear corner. Mark these locations
with a pencil. Center punch and drill a 3/8" hole in
each location. Secure the front hole in the Bow Mount
with a 5/16-18 x 1" Phillips Head Bolt, a 5/16" Washer
and a 5/16" Tapping Plate. Once the front hole is se-
cure, raise the bow assembly up and secure the rear
hole in the mount.
For vehicles with factory bow pockets,
use
the Bow Mounts as templates. Center the Bow
Mounts over the tubes in the vehicle body. Mark,
enter punch and drill 3/8" holes. Install the Bow As-
sembly as shown, substituting 5/16-18 Nuts for the
Tapping Plates.
