SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
LOW POWER SETTINGS
Over Power Delay Time (Povr Over dELy) :
It may be set between 1 – 300 sec. If the measured power
exceeds the set power value than the relay contact is
released at the end of the delay time.
Over Power Mistake Repair Time
(Povr Over dLy0) :
It
may be set between 1 – 300 sec.
Over Power Hysteresis Value (Povr Over
HySt) :
It may be set between % (1 – 30)
Low Power Set Value
(Povr Undr Val):
It may be set to the value where the relay should be
released when low power is supplied.
Low Power Alarm Permit (Povr Undr
EnbL) :
YES ; alarm mode enabled
NO; alarm mode disabled
Low Power Alarm Mode Setting (Povr Undr tyPE) :
Alarm mode:
when alarm is set alarm relay is pulled. When
alarm is disabled alarm relay releases.
Latch mode:
when alarm mode is set alarm relay is pulled.
Alarm relay remains pulled even the alarm is disabled.
If latch
mode iset in models with alarm function, alarm should be
certainly disabled by pressing the set key.
Momentary mode:
In this mode, as an extra
the time seen in the adjacent box is displayed .
It may bet set between 300 msn and 5000msn.
When alarm is set, alarm relay remains pulled
until the end of this time then it is released.
This function may be used when continuous
alarm is not intended.
Low Power Delay Time (Povr Undr dELy) :
It may be set between 1-300 sec. If the measured power
falls below the set power value, relay contact is released at
the end of the delay time.
Low Power Mistake Repair Time
(Povr Undr dLy0) :
It
may be set between
1 – 300 s
ec
Low Power Hysteresis Value (Povr Undr
HySt) :
It may be set between % (1 – 30)
Exit from Low Power
Settings
Exit from Over
Settings
