KAEL DC-MULTISER-1UH-DIN, Manual

Page: 10 / 13

SET SET
SET
SET SET
SET
SET
SET
SET
SET
SET
SET
PULSE OUTPUT SETTINGS
ANALOGUE OUTPUT SETTINGS
Analogue output enabled
Analogue output disabled
Analogue Output Permit
Pulse Types
Pulse output disabled
Total energy
Export Ener gy
Import Ener gy
Analogue Parameters
Voltage (V)
Current (A)
Power (W)
Voltage output type
V
V
V
V
Current output type
mA
mA
The device allows the below
parameters be set as analogue output .
t (msn)
t (msn)
Ps
Ener gy
5 – 24V
Max 30V
PuLS timE :
P ulse time (Ps)
It may be set between 50msn – 900 msn .
P ulse OFF Time (Po) is fixed at 1000 msn.
dEAL :
1 p ulse equivalent energy
It may bet set between 0,1kWh – 1kWh – 10kWh – 100kWh –
10000kWh – 50000kWh
Operation Range Setting
In this mode operation is carried out disregarding the symbol of
the measured value
In this mode, measred value may be set between (+) % 100 .......
This menu is displayed when PErC is selected in the Analog ue measurement
range (An rAng) . This screen does not appear in other modes
In this mode, output may be given at any value between (+) % 100 ....... (-) % 100
for measured value
Ps Ps
dEAL
dEAL
dEAL
1000ms
1000ms
(%) Upper Limit
(%) Lower Limit
Exit from parameter
programming menu
(-) % 100 and output is given accordingly . This will be described in
details in the following menu below .
In this mode output is given only for the measured values between
(+) % 100 - (-) % 100 . This mode is the same as the operation
mode when (PerC) mod e is set with the widest limits .
NOTE1 : (%) Upper Limit Value should be greater than (%) Lower Limit Value
(%) Upper Limit Value cannot be set as % 0 .
NOTE2 : When measured value is outside the (%) lower limit value, Analogue
output will be V/1V or 0mA/4mA. Analogue output may be max. 6V, 12V,
24mA.